|
   .
A.
Automated Pinion Teeth Chamfering Machine - TTG-01 (hand
loading)
B.
Automated Pinion Teeth Chamfering Machine - TTG-01C (with full
automated loading and unloading chain magazine)
A. Automated
Pinion Teeth Chamfering Machine - TTG-01
(hand loading)
Description
The Chamfer-grinding machine is designed specifically for restoring worn
out car starter pinions.
The machine is equipped with two grinding spindle units which can be set
up in different positions by linear displacement in three directions.
Features
 | Extremely high wear resistance making the frequent sharpening and tool
position resetting unnecessary which would have to be done if ordinary grinding wheels
were used
|
| High efficiency
|
| Lower tool cost rate per machined part
|
| Better surface finish
|
| No abrasive particles to be eliminated from the coolant
|
Parameters
PARAMETER |
VALUE |
| 1. Pinion diameter, max mm |
60 |
| 2. Pinion height, max mm |
55 |
| 3. Hole diameter, min mm |
11 |
| 4. Tooth size range, DP |
12...6 |
| Tooth size range (module) , mm |
2...4 |
| Grinding tool diameter, mm |
75 |
| Spindle drive power( each spindle),kW |
1.1 |
| Approximate cycle time per tooth, s |
2.5 |
| Power supply |
upon request |
| Air pressure supply, bar |
6 |
| Floor space, m |
0.97x0.76 |
| Weight, kg |
400 |
Back to top
B. Automated
Pinion Teeth Chamfering Machine - TTG-01C
(with fully automated loading and
unloading chain magazine)
 
PARAMETER |
VALUE |
| 1. Pinion diameter, max mm |
60 |
| 2. Pinion height, max mm |
55 |
| 3. Hole diameter, min mm |
11 |
| 4. Tooth size range, DP |
12...6 |
| Tooth size range (module), mm |
2...4 |
| Grinding tool diameter, mm |
75 |
| Spindle drive power (each spindle),kW |
1.1 |
| Approximate cycle time per tooth, s |
2.5 |
| Power supply |
upon request |
| Air pressure supply, bar |
6 |
| Floor space, m |
1.48x1.53 |
| Weight, kg |
480 |
Back to top
Note: All specifications and dimensions are subject of change
without prior notice
|
