Armature Banding Machine

BM-500 Armature Banding Machine

Description

Premium quality Armature Banding Machine model BM-500 can accommodate a variety of small, medium and large armatures for the starter motor manufacturing industry. The BM-500 applies fiberglass tape under high tension, up to 220 lbs. (100 kg), to the wire winding turns outside of the lamination stack so to prevent "flare out" of the end turns, due to centrifugal forces at high rotational speed. Then the armature is heat-baked and the tape becomes a solid shield over the wire. A traversing carriage on the bed of the Banding Machine allows for a complete placement control and layering of the tape onto the windings.

Approximate capacity: 60-80 pcs/hr

FEATURES

	High banding tension (easily adjustable )
	Digital Tension Readout
	Smooth traverse carriage movement for effortless layering
	Pneumatic carriage locks for precise single position placement
	Simple, robust design
	Computerized control of the entire process; warning is issued if the banding process is not successful
	Readjustment time is only ten minutes
	User-friendly interface
	LCD display of all technical and geometrical parameters and current status of the process
	Self-diagnostic troubleshooting system

SPECIFICATIONS

	Commutator diameter, mm 28 to 60
	Armature’s shaft length, mm 180 to 500
	Electrical power, Volt; Hz 220; 60 (Other voltages available on request)
	Air pressure supply, bar 6
	Productivity , pcs/hour up to 100

Back to top

Note: All specifications and dimensions are subject to change without prior notice.

M&T-2001 Limited All contents copyright ©, 2001-20010 All rights reserved

This page was last updated on February 26, 2010 01:12:42 PM